Wanin USA PV 380 Specifications download pdf (Page 37)

Outdoor Router P-380 Users Guide

Figure 34 – Connected clients statistic table

Refresh – click the button to refresh connected clients statistic information.

6.6.2 Loopback Test

The loopback test is used for wireless link diagnostics. The loopback test graphically shows the data

transfer rate in Mb/s between the P-380 and a specified wireless network device. The transfer rate is

measured by sending an ICMP stream to the specific device. Data is refreshed every 10 seconds.

Figure 35 – Loopback test results

To start the loopback test, do the following:

Endpoint IP – specify the device’s IP address, whose transfer rate needs to be measured.

Start – click to start measuring the specified wireless link.

The status line will show the last measured data transfer rate and the time when this data was

received from the wireless network device.

To stop loopback testing simply click the Stop button.

Gemtek Systems Page 37

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 66 67

No comments

Wanin USA PV 380 Specifications Page 37