Wanin USA PV 380 Specifications Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 67
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
Outdoor Router P-380 Users Guide
4.2 Operating Modes
The P-380 can work in different operating modes:
bridge
access point (AP)
AP router
client router
client bridge
Even if a P-380 is connected to a wired network on one side and to a wireless network on the other
side in all operating modes, there are some significant differences. The operating modes differ from
each other by the possibilities to connect single or multiple stations in the same or in diffent IP
subnets:
How many wireless connections are allowed?
How many wired connections are allowed?
Are connections possible to between different IP subnets?
Which IP addresses are used by the device?
To which wireless types can the P-380 connect remotely?
Is the wired network or the wireless network supposed to be the local area network (LAN)?
The last point is a key for understanding the IP settings including DHCP settings, IP masquerading or
network address translation (NAT) and IP routing. The terms LAN and WAN depend on the devices
operating mode.
Internet
Wired network
(WAN)
Wirless network
(LAN)
WANLAN
Wirless network
(WAN)
Wired network
(LAN)
P-380 in
AP router
mode
P-380 in
client router
mode
Internet
Gateway
Gateway
at ISPs site
IP subnet 192.168.100.0 IP subnet 80.146.72.0IP subnet 192.168.99.0IP subnet 192.168.200.0
Building 2Building 1
Figure 1 – Meaning of LAN and WAN in a P-380 topology
In the figure shown above we connect a subnet 192.168.200.0 in building 1 using a P-380 in client
router mode and a P-380 in AP router mode to a subnet 192.168.100.0 in building 2. On the client
routers side, the wired stations build his local network LAN, the wireless subnet 192.168.99.0
therefore must be the WAN. On the other hand the AP router assumes his wired network to be the
WAN, where it can find an internet gateway. In this case, the wireless network builds up the AP
routers LAN. Going one step further, the internet gateway in the companies building 2 will take the
wired network 192.168.100.0 for LAN and the ISPs subnet for WAN.
The following sections will give a short introduction in each of the operating modes.
Gemtek Systems Page 11
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 66 67

Comments to this Manuals

No comments