Wanin USA PV 380 Specifications download pdf (Page 25)

Outdoor Router P-380 Users Guide

6.4 Setup Wizard

Note: No settings on the setup wizard pages are stored until you press the save

settings button on the wireless configuration setting page at the end of the wizard!

6.4.1 Operating Mode

On the first page of the setup wizard you can select the operating mode.

Figure 18 – Operating mode settings

Select AP Router mode if you want to allow mobile stations to access your wired network and you

need to build up a wireless connection to a different IP subnet.

Select AP (Access point) mode if you want to allow mobile stations to access your wired network.

Select Bridge mode if you want to connect two or more separate wired networks.

Select Client Router mode if you want to connect a whole IP subnet (workgroup) to an AP router in

another IP subnet.

Select Client Bridge mode if you want to connect a workstation to an access point or AP router.

Please note: to run the P-380 in client bridge or client router mode you need a client

firmware from the P-380 product CD!

Please refer to the Operating Modes section for more details about the different modes.

6.4.2 General Configuration Settings

On the general settings page you can specify information about the name and location of your P-380.

Figure 19 – General configuration settings

Gemtek Systems Page 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 66 67

No comments

Wanin USA PV 380 Specifications Page 25